I was taking off the original alternator from a 1995 Toyota Tercel. It was so rusted up I sprayed it once with Trick Shot®, let it sit a few minutes and it seeped through and loosened the bolts right up. It worked great and saved me time!

-Redus B., owner, Auto Repair Shop, PA

We sell and service all types of recreational vehicles including boats. Our mechanics swear by Trick Shot®, they say it outperforms everything they have used before and really like the fact that it is non-flammable.

-Anthony C., Service/Parts Manager, SC

I work on all kinds of boats and many of them are neglected and in pretty rough shape. I tried Trick Shot® and now use it to loosen stuck rusted bolts and nuts. It also does a great job lubricating and it lasts.

-Rob P., Independent Service Technician, FL

Trick Shot® is thicker than other products. It doesn’t run off, stays right where I spray it and does the job. When I heat up a bolt and spray on Trick Shot®, it doesn’t smoke and there’s no toxic chemical smell that other products have. I also use it to prevent parts from rusting so it’s easier next time the car comes in for service. I used to have a cabinet full of products that claim to loosen rusted bolts, but once I tried Trick Shot®, I got rid of all of them.

-David G., ASE Master Mechanic, PA

I tend to be very careful about working with new products, but I tested Trick Shot® in our race shop last Fall, and I rely on its ability to eliminate rust, fight corrosion, and basically solve a number of handyman and clean-up tasks. We use it on our boats and trailers not only because it works, but also because it’s safe in the water! I look forward to a great partnership in 2012 and beyond!

-Dana Tomes, President, Herd Racing and team Pilot

As an environmental management and response company, it’s important for us to do the job right, and our mission is to “Make the Earth a Better Place.” Trick Shot® has become our cleaner of choice, and its biodegradability meets our expectations for environmental responsibility!

-Sterling Ayers, Operations Manager of ECO-FIRST, INC.

A large part of our stamping business is running brake shims for the automotive industry. The shim material consists of two pieces of steel bonded together with an adhesive. Adhesive buildup on the punches and dies has always been a problem. Typically we have to stop and clean the tool every five to six thousand pieces and this is using a silicone based grease on the die set. Well I tried Trick Shot® and a newly sharpened die set and to my amazement we ran 30,000 pieces without a stop to clean. I am sold on Trick Shot®! We will not use anything else from here on out!

– Dave Suponski, PT&D Inc.